How to Fix Squeaky Hardwood Floors: Causes and Repairs
Most squeaks come from movement: a board rubbing against its neighbor, or the subfloor moving on a joist or a loose nail. Knowing how to fix squeaky hardwood floors starts with finding which of those is happening, then stopping the movement, either from below through a basement or crawl space or from above with small screws that are hidden in the floor. A squeak that spreads over a large area or comes with a soft, bouncy spot points to a subfloor problem that needs a professional look.
This guide explains why floors squeak, how to locate the source, which fixes a homeowner can try and when to call a flooring contractor.
Why do hardwood floors squeak?
Hardwood floors squeak when something that should be fixed in place can move. The noise is wood rubbing on wood, or a nail sliding in and out of its hole.
- Boards rubbing against each other at the tongue and groove
- Nails that have loosened over the years, so the board lifts slightly with each step
- Gaps between the subfloor and a joist, often from lumber that shrank as it dried
- Subfloor panels that were not glued or screwed well during construction
- Seasonal movement: wood shrinks in dry winter air and swells in humid summers, which opens and closes small gaps
Seasonal squeaks are the reason a floor can be quiet in July and noisy in January. If boards are also lifting at the edges, the cause may be moisture instead, which our post on hardwood floors cupping explains.
How do you find where the squeak comes from?
Find it by walking the area slowly, ideally with a helper. One person steps on the floor while the other listens, and from a basement or crawl space, watches the subfloor and joists for movement.
- Mark each squeaky spot with painter's tape
- Note whether the noise is under one board or spread across a strip
- Check whether the spot runs along a joist line, which often shows as a row of nail heads in the subfloor below
- Feel for any soft or bouncy area, which is a different and more serious sign
How do you fix a squeaky floor from below?
If you can reach the underside of the floor, fixing it from below is usually the cleanest option because nothing touches the finished surface.
- Thin wood shims tapped gently into a gap between the joist and the subfloor, with a little wood glue, stop the subfloor from moving down
- Short screws driven up through the subfloor into the hardwood pull a loose board down; the screw must be shorter than the combined thickness so it does not come through the top
- A wood block glued and screwed to the side of a joist supports a section of subfloor that has lost contact
Do not hammer shims in hard, because that can lift the floor and create a new hump. Before you drive any screw, check for pipes, ducts and wires.
How do you fix squeaky hardwood floors from above?
When there is no access from below, as on a second floor or over a finished basement ceiling, the repair is made from the top. Small trim-head screws or special snap-off screws are driven through the board into a joist, then the head is set below the surface and the hole is filled with matching wood filler.
For noise from boards rubbing against each other, a dry lubricant such as powdered graphite or talc worked into the seam can quiet it. It does not stop movement, so it is a fix for minor squeaks only.
Repairs from above leave small filled spots, which is why many homeowners prefer to have them done before or during a refinish.
When is a squeak a sign of a bigger problem?
A squeak is usually harmless, but some signs mean the floor or the structure below needs attention:
- A soft, sagging or bouncy area under foot
- Squeaks across a whole room that keep getting worse
- Boards that move visibly or have gaps opening along their length
- Squeaks together with cupping, staining or a musty smell, which suggest moisture
- A floor that was recently installed and squeaks in many places
In these cases, the fix is in the subfloor or the fastening, not in a single board. DNH Hardwood Flooring LLC lists squeak and subfloor repair on its Raleigh flooring contractor page, describing it as fixing loose planks and noisy subfloors before a new surface goes down.
How do you prevent squeaks in a new floor?
Prevention happens before the first board goes down. The subfloor should be flat, clean and firmly fastened, and the wood should adjust to the home's humidity before installation. DNH describes both steps in its process: at least 72 hours of acclimation on site and a crew that levels, cleans and secures the underlayment for a squeak-free base. Keeping indoor humidity steady across the seasons also reduces the movement that causes squeaks later.
Frequently asked questions about squeaky hardwood floors
Are squeaky hardwood floors a structural problem?
Usually not. Most squeaks come from loose nails or small gaps between the subfloor and a joist. A squeak becomes a concern when it comes with soft spots, sagging or signs of moisture, and then the floor should be inspected.
Why do my floors squeak more in winter?
Heating dries the indoor air, and wood shrinks as it loses moisture. Small gaps open between boards and around nails, so pieces that were tight in summer can move and rub. A steadier indoor humidity often reduces seasonal squeaks.
Can I fix a squeaky floor without damaging the finish?
Yes, if you can work from below through a basement or crawl space. Shims, blocking and short screws from underneath leave the top surface untouched. Repairs from above leave small filled holes that blend in but are not invisible.
Will refinishing a floor stop the squeaks?
No. Sanding and refinishing renew the surface but do not change how the boards are fastened. It is a good moment to fix squeaks, though, because any filled screw holes are finished along with the rest of the floor.
Have squeaky floors checked by DNH Hardwood Flooring LLC
DNH Hardwood Flooring LLC is a family-owned flooring contractor founded in 2018 in Durham, NC. It offers hardwood floor installation, repair and refinishing in Durham, Raleigh, Chapel Hill, Cary, Apex, Holly Springs, Wake Forest and Clayton. If a squeak is spreading or the floor feels soft, call 919-225-9420 or contact DNH Hardwood Flooring LLC for a free on-site estimate.
